SAW GENIE PD SUPPLIER INCREASING CLEANING EFFICIENCY BY SUPPLYING HOT AIR TO THE DEVICE
Keywords:
Keywords: Saw gin, Saw tooth geometry, Working chamber, Ginning process, Fiber, cylinder.Abstract
Annotation: In this article, the improvement of the efficiency of cleaning cotton
wool from small impurities by supplying hot air to the PD-tamin laminating device.
References
REFERENCES
Yu. Ergashev, A. Sh. Khusanova, M. Babayeva. Analysis of dynamic
characteristics of selective technology of sawing // FarPI Scientific-Technical Journal-
Fergana 2020 №1 B.252-2555
A. Sh. Khusanova. Optimization of geometric dimensions of ginning elements
of selective technologies // FarPI "Journal of Scientific Technology" Issue 4.
"Optimization of geometric dimensions of ginning elements of selective technologies"
Fergana-2020 P.158-160
A. Salimov, Sh. A. Khusanova. Analysis of experience in the introduction of
modern information and communication technologies in ginneries. Republican
scientific-technical conference International scientific-educational electronic journal.
No. A3-21.10.2020.
A. Salimov, O. Salimov, Sh. Khusanova, I. Khakimov "The problems of
natural fiber and textile materials on fire resistance" Saarj journal Akademicia: an
international multidisciplinary research journal April-2020. https://saarj. com/wp-
content/uploads/special-issue/2020/ACADEMICIA-JULY-2020-SPECIAL-
ISSUE.pdf
O.Sh. Sarimsakov, NM Sattoriv, ZASiddikov, Sh.A. Khusanova.
Improvement of the Process in Disassembling of Cotton Stack and Transferring the
Cotton into Pneumotransport// International Journal of Advanced Science and
Technology Vol. 29, No. 7, (2020), pp. 10849-10857
Yu. Ergashev, A. Sh. Khusanova, O. Sh. Sarimsakov, Kh. Turdiyev, J. Oripov.
Selective technologies of sawing Fergana Polytechnic Institute "Selective technologies
of sawing madness" "Classic" publishing house-2020 ISBN: 978-9943-6662-7-6.
